Digiop BLK-IPS101 Guia de preparacion descargar pdf (Pagina 14)

www.digiop.com

SECTION 3: SYSTEM SETUP

1. Install and setup all analog cameras in their surveillance locations in accordance with the manufactures suggested

procedures.

2. Route the video/audio/power extension cable from each camera to the location where the hDVR is installed.

NOTE

Typically, the power connectors on video extension cables are dierent at each end. When routing these cables, ensure that the

connectors match the devices they attach to.

3.7 Connect analog cameras to hDVR (hDVR systems only)

Analog cameras are assigned to camera channels in the DIGIOPCore software by attaching them to the video connector associated

with the channel. Similarly, audio sources are associated with camera channels by attaching them to the audio connector associated

with the camera channel.

1. Connect the video adapter cable(s) provided with your system to the video capture card in the expansion slot of the

computer. The video capture card in some computers accommodate a single 16-channel adapter with BNC and a DVI-style

connector, another type provides an 8-channel adapter with BNC and a VGA style connector. Notice that all BNC connectors

are labeled for the channel number assigned to the connector. (See the images below for your system.)

Power Supply

Diagnostic

Light

Power Supply

Diagnostic

Button

Security Cable Slot

Back Panel

Connectors

Expansion

Card Slots

Padlock Ring

Power

Connector

OptiPlex 990 backpanel (AI, AH, PH series systems)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 46 47

Sin comentarios

Digiop BLK-IPS101 Guia de preparacion Pagina 14