Digiop BLK-IPS101 Guia de preparacion Pagina 17
- Pagina / 47
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
13NVR and hDVR Systems Setup Guide
SECTION 3: SYSTEM SETUP
Make I/O connections
Make connection to sensors (input), relays (output) and an RS485 trunk as needed (see connector diagrams above). When selecting
the wire size and color for these connections, follow local codes.
Sensor inputs can be congured in the DIGIOPCore software to trigger recording of one camera or more cameras. Sensors and relays
can be normally open (NO) or normally closed (NC) type devices.
RS485 terminals (TRX +/–, RX +/–) provide a 4-wire RS485 interface.
3.8 Congure NVR/hDVR clock and network settings
Your NVR/hDVR server, buy default, is congured to acquire network settings from a DHCP server. Since DHCP congured devices
have changeable network settings, it is suggested that you congure your server with static settings to simplify connecting to it
from other computers. Only IPv4 is supported. If you prefer to retain the default DHCP setup, skip this procedure.
Within the initial system conguration, changing the NVR network settings are performed using Windows 7 procedures (see
below). hDVR network settings are congured through the DIGIOP® Core 8 Kiosk Mode interface.
WARNING
!
Before powering on your server, make sure the power sources are grounded. This helps prevent personal injury or
damage to the equipment.
1. Before connecting the power, ensure that the power source conguration switch on the back of the computer is set to
110 VAC.
2. Make sure all cables are securely attached.
3.8.1 Conguring NVR clock and network settings (AI, EI series systems)
1. Power on NVR and allow it to progress to the windows desktop display.
- Systems Setup Guide 1
- Revision History 2
- Table of Contents 3
- Systems Overview 5
- SECTION 1: SYSTEM OVERVIEW 6
- 2.1 Unpacking the equipment 7
- 2.2 System installation tips 7
- System Setup 10
- SECTION 3: SYSTEM SETUP 11
- Typical video adapter cable 15
- LOGIN TO DIGIOP® CONTROL 24
- ADD IP CAMERAS 25
- EDIT CAMERA SETTINGS 27
- COPYING A CAMERA SCHEDULE 32
- Example List of Systems 36
- DIGIOP® Video Server 37
- APPENDIX A 38
- B.1 IP Camera reset 39
- B.2.1 Checking your Firmware 40
- B.3 Support 40
- Power over Ethernet 41
- D.1 Install IPAdmin Tool 42
- Static 44
- Typical initial camera view 45
- Device Log 46
- Analog Camera Device Summary 47
Relacionado con productos y manuales para Cámaras De Seguridad Digiop BLK-IPS101
(34 paginas)
(21 paginas)Atag VA61313MT manuels
Manuels d'utilisation et guides de l'utilisateur pour Non Atag VA61313MT.
Nous fournissons des manuels en pdf 1 Atag VA61313MT à télécharger gratuitement par type de document : Fiche d'information
Comentarios a estos manuales