Digiop DI Series Manual de usuario descargar pdf (Pagina 10)

www.digiop.com

SECTION 2: INSTALLATION AND SETUP

Relay type sensor wiring schematic

To connect a sensor to the encoder:

1. Route sensor wiring to the encoder.

2. Strip 1/4” of insulation from one sensor’s sense and ground wires and insert them into the upper terminal block in the DI ch 1

and DI GND pin locations, respectively.

3. Strip 1/4” of insulation from another sensor’s sense and ground wires and insert them into the upper terminal block in the DI

ch 2 and DI GND pin locations, respectively.

2.4.3 Digital out (DO) connection

The encoder supports up to two digital out connections to reporting devices in the conguration shown in the schematic below.

Digital out wiring schematic

To connect digital out reporting device to the encoder:

1. Route leads from the digital out devices to the encoder.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 34 35

Sin comentarios

Digiop DI Series Manual de usuario Pagina 10